Hydraulic steel cable swaging machine are widely used in wire rope industry.
Steel cable swaging machine has features of small volume, lightweight, strong durability, easy to operate and can be applied to any task in its field of operation.
1. Add 46# anti-wear hydraulic oil whose quality meet GB/T7631.2-1987.
2. Add oil to be full
3. Connect wires
4. turn on key switch (see the orange light), inching the motor, ensure the motor is running clockwise; make system be running no-load 3~5 minutes. (If the piston doesn't rise or fall when operate petal switch after connect the line, please change the way of three firewire and try again )
5. Fix fitted mould, tight the bolts on the left of both tool set ( the tool is offered by factory); Refer diameter of wire rope table to adjust pressure, put sleeve with steel wire rope in the middle of mould Vertically.
6. Operate pedal rise switch, the piston will rise and the rising pilot lamp lights; Auto-stop when reach given pressure and finish pressing; Operate descendent switch, the piston will descend and the descendent pilot lamp lights; and take out pressed steel wire rope.
|Max press power (KN)||2000kn|
|Max wire rope diameter in one pressing||20mm|
|Max wire rope diameter in multi-pressing||24mm|
|Max working pressure||56Mpa|
|Max piston movement||80mm|
|The speed of piston||8mm/sec|